Find content
Male
Display name history
Posts I've Made
In Topic: HOW FAR POLITICIANS WILL GO TO GET THEIR MESSAGE ACROSS
Yesterday, 02:31 PM
Dinsdale Piranha, on 18 May 2013 - 01:48 PM, said:
Trevor., on 18 May 2013 - 01:24 PM, said:
At a largely Hispanic gathering, it was clear that someone had worried about communication problems and how to get the message across that O'Bummer really did care about these people.
On leaving the rally people were handed a package, and when little Pedro grabbed it from Mamacita just in case it was sweeties, Mama noticed the strange look on his face and asked what it was.
'It looks like half a big mouse Mama', he responded and tossed it over the fence into a building site. She gave him a funny look and shrugged it off.
Talking to her neighbour the next day the neighbour asked if she'd been given a package, and she said yes and repeated what she'd been told. The neighbour snorted and said 'big mouse my derriere, it was half a rat, the back end'.
'Why would anyone hand out half a rat'?
On leaving the rally people were handed a package, and when little Pedro grabbed it from Mamacita just in case it was sweeties, Mama noticed the strange look on his face and asked what it was.
'It looks like half a big mouse Mama', he responded and tossed it over the fence into a building site. She gave him a funny look and shrugged it off.
Talking to her neighbour the next day the neighbour asked if she'd been given a package, and she said yes and repeated what she'd been told. The neighbour snorted and said 'big mouse my derriere, it was half a rat, the back end'.
'Why would anyone hand out half a rat'?
Obama personally couldn't give a rats ass, so he pays someone else to do it.
In Topic: The MODS have ruined this place
Yesterday, 11:03 AM
Oh the devastating shame of it. 
In Topic: ISOLATED CONTAINED CARGO ITEM
Yesterday, 10:58 AM
Suspicious Baggage, on 18 May 2013 - 10:35 AM, said:
good luck, man
Got pissed off a couple of times but got there in the end - so your digs weren't wasted.
The only thing which is totally new is the iron-on film, but we printed on the stuff, and the artwork was superb, even thin tracks. As you can see there are no thin tracks, and definitely none which go between chip pins.
The acid etching of the board with Ferric Chloride I've done many times, we have no worries there, as long as the 2 artworks for top and bottom are registered properly, we'll be okay.
I've found my full A4 double sided copper-clad board, so will lay out multiple prints, say 5 complete boards both sides. That way there's 5 chances of getting it right, those odds I can deal with. It would cost up to £500 to get them made professionally, but I've made too many in the past to waste that without trying.
Need to set up the software tools, this thing won't do anything without software to set up the signal and control lines. Happily, the simulator does both analogue AND software simulation which is one hell of a tool.
I'll keep you posted on the board production side, should have them within a week, smoking and smouldering happily.
